A modern furnace runs a strict startup sequence, and knowing where the sequence breaks is most of the diagnosis. The thermostat calls, the inducer motor spins up to prove draft through a pressure switch, the hot surface igniter glows, the gas valve opens, the burners light, the flame sensor confirms fire, and only then does the blower deliver heat to the house. In Wellington, FL, the failures cluster at predictable points: an oxide-coated flame sensor, a hot surface igniter cracked from years of thermal cycling, a pressure switch that will not close because the inducer is weak or the condensate trap on a high-efficiency model has clogged, or a control board with a burned relay. Each one stops the sequence cold, and each one mimics the others from the hallway.
When the AC quits in summer, see AC Repair.
Signs You Need Furnace Repair in Wellington
Catching these issues early helps you avoid costly problems. Watch for these telltale signs:
- A bang or boom when the burners ignite late
- The blower runs constantly but the air never warms
- Flames that start, last a few seconds, and go out again and again
- Soot, rust, or moisture near the furnace cabinet or vent pipe
- The furnace clicks and glows but the burners never light
- Grinding or high-pitched squeals from the blower
- Yellow, wavering burner flames where they should be sharp blue
- A furnace that shuts off every few minutes before the house warms up
Act Before It Gets Worse
A failing capacitor, clogged condensate drain, or dirty flame sensor rarely fixes itself and usually gets more expensive to address the longer it runs. Call (561) 652-8025 at the first sign of trouble.
